AMX DX-TX-4K60 · Audio XL

The DX-TX-4K60 can send high-definition video, analog audio, control, and Ethernet over standard twisted-pair cable (CAT6a or better) from up to 100 meters away to a router with DXLink inputs, point-to-point to a DXLink twisted-pair receiver, or to a device with HDBaseT input.

The compact transmitter can be mounted on or under a table or console. Source control is provided via the built-in RS-232, IR port, TCP/IP, or USB2.0. Source feedback signals can be evaluated to monitor the settings of connected source devices.

Audio signals can be input together with a video signal via the stereo audio input.

Technical Data

Specifications HDMI input: HDMI, DVI-D (single link) and DisplayPort++ (each via additional cable adapters) with full HDCP support.
Connectors: 2x HDMI type A female with mounting thread hole, 1x of which is loop-through output....
Support for maximum resolution: 3840x2160@60 Hz 4:4:4, 3840x2160p@50/60 Hz 4:2:0, 4096x2160p@50/60 Hz 4:2:0, as well as HDR10 (High Data Rate) 36-bit Deep Color.
DXLink output: RJ45 jack, shielded, for use with CAT6a cable or better, up to 100 m cable run to router, presentation switcher, to receiver in point-to-point operation, or send directly to HDBaseT input of a sink.
No interruption when switching HDCP protected image content due to InstaGate Pro technology. For point-to-point operation with receiver module, the number of keys is determined by the source. When operating with ENOVA DGX or DVX, key support sets the number of sinks per output to 16, regardless of the source.
Audio formats digital: Dolby TrueHD, Dolby Digital*, DTS-HD Master Audio, DTS*, 2 CH L-PCM, 6 CH L-PCM, 8 CH L-PCM (* = Dolby Digital and DTS is supported up to 48 kHz, 5.1 channel); audio resolution 16 to 24 bit, audio sample rates: 32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Audio input: 1x 3.5mm stereo jack, stereo analog, +3 dBu unbalanced, impedance 10k ohms
1x 3-pin 3.5 mm Phoenix connector for RS-232 bidirectional for serial control of connected devices.
1x RJ-45 socket for TCP/IP (10/100), for connection of TCP/IP control modules and operator panels, for control of connected devices via TCP/IP and for connection of PC or laptop via Ethernet.
1x 2-pin 3.5 mm Phoenix connector for infrared signal output for controlling the connected devices with IR by means of IR transmitter diode.
1x USB 2.0 socket type A, for connection of devices with High Speed USB 2.0
1x USB HID socket type B, host connection for a PC to control keyboard and mouse functions
Power supply: Via twisted pair cable when used with ENOVA DGX crossbar series with DXLink input card, ENOVA DVX presentation switchers with DXLink inputs, or local power supply via external 12 VDC 1.5 A power supply (included) to 2.1mm hollow connector socket.
Dimensions: 220 x 26 x 160 mm (W x H x D)
Weight 500g